Relay cable set 12v LED-Ramp DT connector (for 1 lamp)

Relay for installation of 1 additional light or 1 LED light ramp up to 200 watts. This relay kit contains everything you need to connect additional lights to your existing high beam.

Comes with a switch for easy installation and lighting (if, for example, you don't want to connect control current to an existing additional light). If you wish to connect the relay cable set so that it lights up at the same time as the existing high beam, you cut off the switch and use the ignition wire (+ the cable).

Can of course be used without the DT connector (plus and minus connection), just cut off the connector.

Simple connection:

The cable set has a total of three cables to be connected:

1. DT connector. Connect to the additional light's DT connector. If there is no DT connector and you want to connect to a cable stub, you can cut off the connector.
2. Control current. Cut off the switch and connect the plus cable to the car's electrical system that turns on the high beams. A simple solution is to connect a "thief" on the car's existing plus supply to the high beams. Then the LED light bar is switched on at the same time as the main beam is switched on.
3. Power source. Connect red cable (positive pole) and black cable (earth/negative pole) to the car's power source. For example, junction box or battery. Done!

Technical specification:

• 1 pc Deutsch DT connectors. Fits, for example, 1 LED light ramp
• Cable length: approx. 3 meters
• Max power: 200 watts
• Fits 12 volt system